DT01721 Replacement Hitachi Projector Lamp TCP-D1100X TCP-D1070U TCP-D1070W

DT01721 For Hitachi Projector Lamp TCP-D1100X TCP-D1070U TCP-D1070W

Product Parameter

 Product Information

The Hitachi DT01721 replacement lamps are compatiable with TCP-D1100X TCP-D1070U TCP-D1070W projectors.The working hour time is:3000-5000 hours,After repalcing our new lamps,the projector performance can be the same of the new original one and improve the effect of projection,and make you feel comfortable while using.

 Online Resources

Many projector manufacturers offer online resources such as user manuals, FAQs, and knowledge bases on their websites. These resources provide valuable information on bulb installation, troubleshooting steps, and general maintenance guidelines.

 Bulb warranty

Use Proper Tools: Prepare the necessary tools for the installation, such as a screwdriver or lamp removal tool, as specified in the user manual. Using the correct tools will ensure a secure and safe installation.

Access the Lamp Compartment: Locate the lamp compartment on your projector. The exact location may vary depending on the projector model. Usually, it is accessible from the top or bottom of the projector or through a side panel. Remove any screws or latches that secure the compartment.

Remove the Old Lamp: Carefully detach the old lamp by following the instructions provided in the user manual. In some cases, the lamp may be held in place by screws or clips. Gently release the lamp and disconnect any cables or connectors attached to it.

Install the New Lamp: Take the new lamp and align it correctly with the lamp housing. Make sure it fits securely and matches the connections of the previous lamp. Reconnect any cables or connectors that were disconnected during the removal process.

Secure the Lamp Compartment: Once the new lamp is in place, secure the lamp compartment by reattaching any screws or latches that were removed earlier. Ensure that the compartment is sealed properly to prevent any dust or debris from entering.