MU04951 Hitachi Projector Filter General CP-X308 CP-X400 Projector Filter Replacement

MU04951 filter for Hitachi projector General CP-X308, CP-X400 Projector Filter

Product Parameter

Points to note

1. Prepare tools

Cleaning the filter requires some basic tools: soft brush, clean cotton cloth or fine-bristled brush, bottled gas.

2. Power outage or shutdown

Before cleaning, you need to power off the projector or turn it off for safety.

3. Remove the filter

To remove the projector filter, you need to follow the instructions or operating guide. Do not use excessive force or you may damage the filter or machine.

4. Clean the filter

Before cleaning the filter, you can wipe it with a clean cotton cloth to remove larger foreign matter. Then use a soft-bristled brush to gently remove dust. Brush lightly from top to bottom. Do not use excessive force to avoid damaging the bristles. For items that are difficult to clean, use bottled gas or a spray gun to remove dust. At this time, keep a certain distance and don't spray too much.

5. Install the filter

Reinstall the cleaned filter back into the projector. If you find that there is still dust on the filter, you need to clean it again.

To sum up, cleaning the projector filter is relatively simple, but you must pay attention to safety and gentleness, and do not use too rough methods to clean, so as not to affect the service life. The frequency of cleaning the projector filter can be determined according to actual conditions. Cleaning is recommended at least quarterly. It can also be determined based on the intensity of daily use to ensure the normal operation of the machine and improve the projection effect.